The yellow line on the subway map.

• outer rail = clockwise
• inner rail = anti-clockwise

• tab - dead man switch
• W - forward
• C - drive mode
• U - centre camera
• F12 - screen shot
• shift click - action mode
• space - exit action mode
• PgUp - selector
• 1,2,3 - clock, route, current station
• L - headLights
• V - cab Vent
• END - passenger lights
• B - saloon heating
• F5 / F6 - passenger doors
• F7 / F8 - driver doors
• Ctrl left or right - look back (if you leave cab, reactivate deadman switch)
• H - horn
• X - wipers

1. Enter rear cab and turn on tail lights and dest. light
2. Set dest then leave the cab (shut the door)
3. Go to front cab
4. Sit
5. Selector to 'Auto' PgDn
6. TBC to 'service application' up
7. Turn on cablights, dest, dash, vent
8. Turn on heater and passenger lights
9. Exit action mode (space)
10. Set desto.
11. TBC to 'rheostatic 2 and EP application' up
12. On right panel click "lamp test"
13. Switch to "brake test" and yellow lights should illuminate
14. TBC to "service application" dn - red lights should illuminate
15. TBC to "rheostatic 2 and EP application"
16. Turn off brake test.
17. DVA digital voice announcer
    1. TBC to service
    2. Press "program"
    3. 2 and 8 to select route
    4. If short service, start and end stations
    5. Press "program" to finish - DVA should show "Automatic Announcer enabled"
    6. 1 = ready, 2 = stand clear, 3 = Terminates, 4 = all change, 5 = delayed, 6 = thankyou, 7 = mtg, 8 = no smoking, 9 = train held.
    7. If the TBC is set to shutdown, the DVA has to be reprogrammed.
    8. Before closed station Blackfriars, press "Closed station"
    9. At final station (except Edgware Road and Hammersmith), press 3 advising of termination.
18. Blue light = doors closed
19. Open doors
20. Ctl to look back
21. Close cab door (F7 or F8)
22. Check signal and move off - remember you might need to tab deadman's switch

1. Close doors
2. Selector to

C:\Program Files (x86)\Steam\userdata\1104364819\760\remote\283620\screenshots